51-19
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 51 Configuring Multicast Services
Configuring IGMP Snooping on the Switch
Group and Source Specific Queries: 0
Reports: 0
Leaves: 0
Total Valid pkts: 20
Total Invalid pkts: 0
Other pkts: 5
MAC-Based General Queries: 0
Failures to add GDA to EARL: 0
Topology Notifications: 0
IGMP packets dropped: 0
IGMP Leave msgs in the list: 0
IGMP V3 IS_IN messages: 0
IGMP V3 IS_EX messages: 0
IGMP V3 TO_IN messages: 0
IGMP V3 TO_EX messages: 0
IGMP V3 ALLOW messages: 0
IGMP V3 BLOCK messages: 0
Console> (enable)
Disabling IGMP Fast-Leave Processing
To disable IGMP fast-leave processing, perform this task in privileged mode:
This example shows how to disable IGMP fast-leave processing:
Console> (enable) set igmp fastleave disable
IGMP fastleave set to disable.
Console> (enable)
Disabling IGMP Snooping
To disable IGMP snooping, perform this task in privileged mode:
This example shows how to disable IGMP snooping:
Console> (enable) set igmp disable
IGMP feature for IP multicast disabled
Console> (enable)
Task Command
Disable IGMP fast-leave processing. set igmp fastleave disable
Task Command
Disable IGMP snooping. set igmp disable
To Next Page
Loading...
