17-8
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 17 Configuring GVRP
Configuring GVRP on the Switch
Displaying GVRP Statistics
To display the GVRP statistics on the switch, perform this task:
This example shows how to display the GVRP statistics for port 1/1:
Console> (enable) show gvrp statistics 1/1
Join Empty Received: 0
Join In Received: 0
Empty Received: 0
LeaveIn Received: 0
Leave Empty Received: 0
Leave All Received: 40
Join Empty Transmitted: 156
Join In Transmitted: 0
Empty Transmitted: 0
Leave In Transmitted: 0
Leave Empty Transmitted: 0
Leave All Transmitted: 41
VTP Message Received: 0
Console> (enable)
Clearing GVRP Statistics
To clear all the GVRP statistics on the switch, perform this task in privileged mode:
This example shows how to clear all the GVRP statistics on the switch:
Console> (enable) clear gvrp statistics all
GVRP Statistics cleared for all ports.
Console> (enable)
Disabling GVRP on Individual 802.1Q Trunk Ports
To disable GVRP on the individual 802.1Q trunk ports, perform this task in privileged mode:
Task Command
Display the GVRP statistics. show gvrp statistics [mod/port]
Task Command
Clear the GVRP statistics. clear gvrp statistics {mod/port | all}
Task Command
Step 1
Disable GVRP on an individual 802.1Q trunk
port.
set port gvrp disable mod/port
Step 2
Verify the configuration. show gvrp configuration
To Next Page
Loading...
