Cisco WS-C6506 - Displaying the Configuration for the CAM Monitor; Displaying the Global Configuration for the CAM Monitor

38-18
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 38 Configuring Port Security
Configuring MAC-Address Monitoring
This example shows how to clear all CAM table monitoring and MAC-address monitoring
configurations from all ports:
Console> (enable) clear cam monitor all
Cleared all cam monitor configuration
Console> (enable)
Displaying the Configuration for the CAM Monitor
To display the configuration for the CAM monitor, perform this task in privileged mode:
This example shows how to display the configuration for the CAM monitor:
Console> (enable) show cam monitor all
Cam monitor global configuration:
status : enabled
interval : 5 seconds
* = violation occured
Port Status Low Low High High No. of
Threshold Action Threshold Action mac addrs
------ -------- --------- -------- --------- -------- ---------
3/1 enabled 500 warning 32000 warning 0
4/2 enabled 500 warning* 32000 warning 0
Total port entries = 2
Console> (enable)
Displaying the Global Configuration for the CAM Monitor
To display the global CAM monitor configuration, perform this task in privileged mode:
Console> (enable) show cam monitor
Cam monitor global configuration:
status : enabled
interval : 5 seconds
Console> (enable)
Task Command
Display the configuration for the CAM monitor. show cam monitor [mod/port | mod/port vlan |
vlan | all]
Task Command
Display the global configuration for the CAM
monitor.
show cam monitor