21-11
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 21 Configuring GOLD
Configuring Online Diagnostics
Displaying Online Diagnostic Tests and Test Results
You can display the online diagnostic tests that are configured for specific modules and check the results
of the tests using the show commands.
To display online diagnostic test information, perform these tasks in normal mode:
Clearing the Online Diagnostic Configuration
To clear online diagnostic configuration parameters, perform these tasks in normal mode:
Task Command
Display the bootup diagnostic level. show diagnostic bootup level
Display the test content for the specified
module(s) or all modules.
show diagnostic content module [mod_num | all]
Display the configuration settings for the online
diagnostic failure response for the supervisor
engine.
show diagnostic diagfail-action
Display the diagnostic event log. show diagnostic events [event-type {error | info
| warning}]
show diagnostic events [module {mod_list | all}]
show diagnostic events
Display the online diagnostic on-demand
configuration settings.
show diagnostic ondemand settings
Display the diagnostic test results for the
specified module(s) or all modules.
show diagnostic result module mod_list | all
[detail | test] [test_list] [detail]
Display the online diagnostic scheduling. show diagnostic schedule module mod_list
Display the current online diagnostic status for all
modules.
show diagnostic status
Task Command
Clear the bootup online diagnostic level. clear diagnostic bootup level
Clear the online diagnostic event-log size. clear diagnostic event-log size
Clear the online diagnostic health-monitoring
configuration.
clear diagnostic monitor interval module
mod_list test [test_list | all]
clear diagnostic monitor module mod test
test_list
clear diagnostic monitor syslog
To Next Page
Loading...
Need help?
General