Cisco WS-C2960L-24TS-LL

Questions and Answers

M
Misty HoganAug 11, 2025
What to do if Cisco WS-C2960L-24TS-LL Switch port has many packet errors or constantly flaps?
- J
  Jennifer GrantAug 11, 2025
  If a Cisco Switch port has many packet errors or constantly flaps, first, examine or exchange the copper or fiber-optic cable with a known, good cable. Also, check for broken or missing pins on cable connectors. Rule out any bad patch panel connections or media converters between the source and the destination. If possible, try the cable in another port or interface to see if the problem follows the cable.
A
Angela LopezAug 17, 2025
What to do if powered device connected to Cisco Switch PoE port does not receive power?
- A
  Allison ReeseAug 18, 2025
  If a powered device connected to a Cisco Switch PoE port does not receive power, use the Mode button to show the PoE status for all ports. Use the show interfaces privileged EXEC command to see if the port is in error-disabled, disabled, or shutdown and reenable the port if necessary. Verify that the power supply installed in the switch meets the power requirements of your connected devices and that there is sufficient PoE power budget to provide power to the attached device. Try replacing the crossover cable with a straight-through cable.
J
Jessica JohnsonAug 23, 2025
Why Cisco WS-C2960L-24TS-LL Switch port LED does not turn on?
- M
  Mary YoungAug 23, 2025
  If a Cisco Switch port LED does not turn on, connect the cable from the switch to a known good device. Make sure that both ends of the cable are connected to the correct ports and that both devices have power. Verify that you are using the correct cable type. Look for loose connections by disconnecting and then reconnecting the cable.
S
stefanie78Aug 29, 2025
What to do if Cisco WS-C2960L-24TS-LL Switch port appears to malfunction?
- M
  mendozadeannaAug 29, 2025
  If a Cisco Switch port appears to malfunction, use the Mode button to show the status for all ports. You can also use the show interfaces privileged EXEC command to see if the port is error-disabled, disabled, or shutdown, and reenable the port if necessary.
T
travishoodSep 4, 2025
How to resolve autonegotiation problems between Cisco Switch and third-party network interface cards (NICs)?
- R
  Rebecca CruzSep 4, 2025
  To resolve autonegotiation problems between the Cisco Switch and third-party network interface cards (NICs), try manually setting both sides of the connection. Also, upgrade the NIC driver to the latest version.

Cisco WS-C2960L-24TS-LL Specifications

General

Model	WS-C2960L-24TS-LL
Product Series	Cisco Catalyst 2960-L
Device Type	Switch
Ports	24
Power over Ethernet (PoE)	No
Jumbo Frame Support	Yes
RAM	512 MB
Power Device	Internal power supply
Width	17.5 in
Layer	Layer 2
Enclosure Type	Desktop
Subtype	Ethernet
Forwarding Rate	35.7 Mpps
Routing Protocol	Static IPv4 routing
Remote Management Protocol	SNMP
Features	DHCP snooping, VLAN support, QoS
Compliant Standards	IEEE 802.3, IEEE 802.1Q
Interfaces	24 x 10/100/1000 Ethernet ports
Voltage Required	100 to 240 VAC
Dimensions (H x W x D)	1.75 x 17.5 x 11.5 in
Height	4.4 cm
Operating Temperature	32 to 113 °F (0 to 45 °C)
Memory	512 MB