Need help?Do you have a question about the Cisco WS-C2960L-8TS-LL and is the answer not in the manual?
General| Model | WS-C2960L-8TS-LL |
|---|---|
| Ports | 8 x 10/100/1000 Ethernet ports |
| Switching Capacity | 16 Gbps |
| Power over Ethernet (PoE) | No |
| Layer | Layer 2 |
| Weight | 3.5 lbs |
| Operating Temperature | 0 to 40°C |
| Power Supply | Internal |
| Flash Memory | 64 MB |
| DRAM | 128 MB |
| Maximum VLANs | 256 |
| Jumbo Frame Support | Yes, up to 9216 bytes |
| Input voltage | 100 to 240 VAC |
| Memory | 128 MB DRAM, 64 MB Flash |
| Product Series | Cisco Catalyst 2960-L |
| Dimensions | 4.4 x 26.8 x 23.6 cm |
| MAC Address Table Size | 8000 |
| Form Factor | Rack-Mountable |
| Dimensions (H x W x D) | 1.75 x 17.5 x 12.0 in |
| Management | CLI |
Lists required equipment and pre-connection checks before setting up the switch.
Details the physical connection steps: powering the switch and connecting it to a PC via Ethernet.
Lists essential information required for the switch configuration process.
Instructions on accessing the switch's Web UI via IP address to initiate the setup wizard.
Guides users through the initial setup wizard for essential switch settings like hostname and passwords.
Configures interface settings, including Data VLAN ID and Voice VLAN ID for network connectivity.
Sets up Layer 3 information, such as default gateway and switch IP/subnet for network access.
Enables advanced features like Telnet and provides a summary of the configuration choices.
Reviews, saves, and enables the final switch configuration settings.
To Next Page