2-1 Before You Begin
Before you begin the configuration, make sure that you have the following information.
●
IP Address of the Default Gateway (Router)
●
IP Address and Subnet Mask for the Switch
2-2
Logging in to Configuration Setup Wizard
When you first set up the switch, use the Configuration Setup Wizard to enter the
initial IP information. Launch a Web browser on your PC, and log in to the Web UI.
1
1
Enter the IP address
"10.0.0.1" into a web
browser address bar, and
press Enter key.
The authentication dialog box
appears.
Configuring Switch
2
Caution
If the authentication dialog box does not appear, make sure that:
・
All the LEDs next to the Mode button turn green.
・
You
connect a straight-through cable to an Ethernet port on the switch and the PC.
・
Any pop-up blockers or proxy settings on your browser are disabled and that any
wireless client is disabled on your PC or laptop.
・
Your PC settings use DHCP. During the Express Setup mode, the switch acts as a DHCP
server. If your PC has a static IP address, temporarily configure your PC settings to use DHCP.
3
2-3 Basic Configuration
After logging in to the Web UI, the Configuration Setup Wizard automatically appears
to help you perform initial configuration.
2
Enter the default
username "cisco" in the
[Username].
3
Enter the default
password "cisco" in the
[Password].
4
Click [OK].
The Configuration Setup Wizard
window appears.
1
Click [GO TO WIZARD].
The BASIC CONFIGURATION
window appears.
4
1
MEMO
The switch has a default IP address "10.0.0.1" and a secondary IP address "10.0.0.3".
2
To Next Page
Loading...
