What to do if file “vmps_configuration.db” not found on the TFTP server on Cisco Switch?
If the file “vmps_configuration.db” is not found on the TFTP server 172.16.254.222 when using a Cisco Switch, check the filename of the VMPS database configuration file on the TFTP server and ensure that the permissions are set correctly.
How to fix 'Unable to contact the TFTP server' error on a Cisco WS-C2948G-GE-TX Switch?
If the Cisco Switch is unable to contact the TFTP server 172.16.254.222, enter a static route to the TFTP server using the set ip route command.
How to configure TFTP server IP address on a Cisco Switch?
If the TFTP server IP address is not configured on your Cisco Switch, specify the TFTP server address using the set vmps tftpserver ip_addr [filename] command.
Why does my Cisco WS-C2948G-GE-TX fail to download the VMPS configuration file due to out of memory?
If the Cisco Switch fails to download the VMPS configuration file due to being out of memory, it might be because the VMPS database file specifies more than 256 different VLANs. To resolve this, reduce the number of VLANs used in the file.
What to do if dynamic port shuts down because VMPS is in secure mode on Cisco Switch?
If a dynamic port shuts down on a Cisco Switch because the VMPS is in secure mode and it is illegal for the host to connect to the port, reenable the dynamic port by entering the set port enable command.
What to do if Cisco Switch download aborted due to file size being larger than download buffer?
If the download is aborted on your Cisco Switch because the file size is larger than the download buffer, it means the VMPS database file is longer than 21051 lines. If possible, shorten the file.
General| Model | WS-C2948G-GE-TX |
|---|---|
| Category | Switch |
| Ports | 48 |
| Uplink Ports | 2 |
| RAM | 128 MB |
| Flash Memory | 32 MB |
| Power Supply | AC |
| Management | CLI, SNMP, Web |
| Operating Temperature | 0 °C to 40 °C |
| Operating Humidity | 10 to 90% non-condensing |
To Next Page