Cisco WS-C2948G-GE-TX - Disabling an Etherchannel; Displaying Spanning Tree-Related Information for Etherchannels

6-22
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Chapter6 Configuring Fast EtherChannel and Gigabit EtherChannel
Configuring EtherChannel Using LACP
Disabling an EtherChannel
To disable an EtherChannel, perform this task for ports 2/2 to 2/8:
This example shows how to disable an EtherChannel:
Console> (enable) set port lacp-channel 2/2-8 mode off
Port(s) 2/2-8 channel mode set to off.
Console> (enable)
Displaying Spanning Tree-Related Information for EtherChannels
You can display the channel ID and the truncated port list for all ports that are channeling. Ports that are
not channeling are identified by their port number.
To display spanning tree-related information for EtherChannels, perform this task:
These examples show how to display spanning tree-related information for EtherChannels:
Console> show spantree 4/6
Port Vlan Port-State Cost Priority Portfast Channel_id
------------------------ ---- ------------- ----- -------- ---------- ----------
4/6 1 not-connected 4 32 disabled 0
Console>
Console> show spantree 4/7-8
Port Vlan Port-State Cost Priority Portfast Channel_id
------------------------ ---- ------------- ----- -------- ---------- ----------
4/7-8 1 blocking 3 32 disabled 770
Console>
Task Command
Disable an EtherChannel. set port lacp-channel mod/port mode off
Task Command
Display spanning-tree related information for
EtherChannels.
show spantree mod/port