Cisco WS-C2960L-8TS-LL - Interface Configuration

2
2
Enter a Hostname.
3
Enter a Username.
4
Enter a Password.
5
Enter a Enable Password.
6
Select the time and date.
7
Click [Interface
Configuration].
The INTERFACE
CONFIGURATION window
appears.
MEMO
The
❺
[Enable Password] controls access to the privileged EXEC mode in the CLI (Command
Line Interface).
4
3
5
7
6
2-4 Interface Configuration
Configure the interface information. As a minimum information in order to connect the
switch to the network, the [Data Vlan] field is required.
1
Enter a Data VLAN ID.
By default, the VLAN ID assigned
to the management interface for
your switch is 1.
2
Enter a Voice VLAN ID.
You can skip this step if your
network does not use a VLAN
for voice traffic.
1
2
Cisco Catalyst 2960-L Series Easy Setup Guide
2
Configuring Switch