Cisco WS-C6506 - Clearing MAC Utilization Counters

20-9
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Configuring the MAC Utilization Load Interval
This example shows how to display MAC utilization statistics for a module:
Console> (enable) show mac utilization 12
30 seconds input/output port rates:
Port Xmit-Packet-Rate Xmit-Octet-Rate Xmit-Bit-Rate
----- -------------------- -------------------- --------------------
12/1 396702 594010991 4752087928
12/2 395978 593964837 4751718696
12/3 412889 619338738 4954709904
12/4 396693 418773370 3350186960
Port Rcv-Packet-Rate Rcv-Octet-Rate Rcv-Bit-Rate
----- -------------------- -------------------- --------------------
12/1 412891 619344814 4954758512
12/2 412891 619340051 4954720408
12/3 395978 593964450 4751715600
12/4 405223 425521134 3404169072
Console> (enable)
This example shows how to display MAC utilization statistics for a port:
Console> (enable) show mac utilization 12/1
30 seconds input/output port rates:
Port Xmit-Packet-Rate Xmit-Octet-Rate Xmit-Bit-Rate
----- -------------------- -------------------- --------------------
12/1 405825 607683712 4861469696
Port Rcv-Packet-Rate Rcv-Octet-Rate Rcv-Bit-Rate
----- -------------------- -------------------- --------------------
12/1 408276 612401845 4899214760
Console> (enable)
Clearing MAC Utilization Counters
To clear the MAC utilization counters, perform this task in enabled mode:
This example shows how to clear the MAC utilization counters for a port:
Console> (enable) clear mac utilization 1/1
Mac utilization counters are cleared for the port 1/1.
This example shows how to clear the MAC utilization counters for a module:
Console> (enable) clear mac utilization 1
Module 1 mac utilization counters are cleared.
This example shows how to clear the MAC utilization counters globally:
Console> (enable) clear mac utilization
Mac utilization counters are cleared.
Task Command
Clear the MAC utilization counters. clear mac utilization [mod/port]
1
1. There is no option for this command.