Cisco WS-C6506 - Configuring IP Device Tracking on a Port; Enabling or Disabling IP Device Tracking on a Port with 802.1 X Authentication; Enabling or Disabling IP Device Tracking on a Port with MAC Authentication Bypass; Enabling or Disabling IP Device Tracking on a Port with Web-Based Proxy Authentication

43-3
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 43 Tracking Host Aging
Configuring IP Device Tracking on a Port
To specify the probe interval, perform this task in privileged mode:
This example shows how to set the IP device tracking interval:
Console> (enable) set ip device-tracking probe interval 45
Device tracking probe interval set to 45 secs.
Console> (enable)
Specifying the IP Device Tracking Count
You can configure IP device tracking to send 1 to 10 probes after the host becomes idle. The default is
3 probes.
To set the probe count, perform this task in privileged mode:
This example shows how to set the IP device tracking probe count:
Console> (enable) set ip device-tracking probe count 5
Device tracking probe count set to 5.
Console> (enable)
Configuring IP Device Tracking on a Port
The following topics describe how to configure IP device tracking on a port:
• Enabling or Disabling IP Device Tracking on a Port with 802.1x Authentication, page 43-4
• Enabling or Disabling IP Device Tracking on a Port with MAC Authentication Bypass, page 43-4
• Enabling or Disabling IP Device Tracking on a Port with Web-Based Proxy Authentication,
page 43-5
• Enabling or Disabling IP Device Tracking on a Port with EoU, page 43-6
Task Command
Specify the time period in seconds to send a probe. set ip device-tracking probe interval
interval
Task Command
Specify the number of times to check for the existence
of a host.
set ip device-tracking probe count count