xxxix
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Preface
Revised:OL-8978-04
This preface describes who should read the Catalyst 6500 Series Switch Software Configuration Guide,
how it is organized, and its document conventions.
Audience
This publication is for experienced network administrators who are responsible for configuring and
maintaining Catalyst 6500 series switches.
Organization
Note This publication includes the information that previously was in the Catalyst 6000 Family Multilayer
Switch Feature Card (12.x) and Policy Feature Card Configuration Guide.
This publication is organized as follows:
Chapter Title Description
Chapter 1 Product Overview Presents an overview of the Catalyst 6500 series switches.
Chapter 2 Command-Line Interfaces Describes how to use the command-line interface (CLI).
Chapter 3 Configuring the Switch IP Address and
Default Gateway
Describes how to perform a baseline configuration of the switch.
Chapter 4 Configuring Ethernet, Fast Ethernet,
Gigabit Ethernet, and 10-Gigabit Ethernet
Switching
Describes how to configure Ethernet, Fast Ethernet, and Gigabit
Ethernet switching.
Chapter 5 Configuring Ethernet VLAN Trunks Describes how to configure Inter-Switch Link (ISL) and
IEEE
802.1Q VLAN trunks on Fast Ethernet and Gigabit
Ethernet ports.
Chapter 6 Configuring EtherChannel Describes how to configure Fast EtherChannel and Gigabit
EtherChannel port bundles.
To Next Page
Loading...
Need help?
General