Cisco WS-C6506 - Detaching an ACL from an Interface

52-57
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 52 Configuring QoS
Configuring QoS on the Switch
This example shows how to attach an ACL named test2 to VLAN 1 to filter the egress traffic:
Console> (enable) set qos acl map test2 1 output
ACL test2 is successfully mapped to vlan 1 on output side.
Console> (enable)
Note The default ACLs do not need to be attached to any interfaces.
Detaching an ACL from an Interface
Note Supervisor Engine 1 with a Layer 2 Switching Engine does not support the commands in this section.
To detach an ACL from a port or a VLAN, perform this task in privileged mode:
Note Only PFC3 supports the input and output keywords.
This example shows how to detach an ACL named my_acl from port 2/1:
Console> (enable) clear qos acl map my_acl 2/1
Hardware programming in progress...
ACL my_acl is detached from port 2/1.
Console> (enable)
This example shows how to detach an ACL named my_acl from VLAN 4:
Console> (enable) clear qos acl map my_acl 4
Hardware programming in progress...
ACL my_acl is detached from vlan 4.
Console> (enable)
Note The default ACLs cannot be detached from any interfaces.
Task Command
Step 1
Detach an ACL from an interface. clear qos acl map acl_name {mod/port [input] |
vlan [input | output]| all}
Step 2
Verify the configuration. show qos acl map {config | runtime} {acl_name
| mod/port | vlan | all}