42-12
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 42 Configuring Web-Based Proxy Authentication
Configuring Web-Based Proxy Authentication
This example shows how to configure the URL for the login page:
Console> (enable) set web-auth login-page url http://proxyauth.cisco.com/login.html
web-auth login-page configured.
Console> (enable)
Configuring the Login-Fail Page URL
When you enter the URL, use this format, url = http://string.
To configure the URL for the login-fail page, perform this task in privileged mode:
This example shows how to configure the URL for the login-fail page:
Console> (enable) set web-auth login-fail-page url http://proxyauth.cisco.com/login.html
web-auth login fail page configured.
Console> (enable)
Specifying the Session Timeout Period
You can specify the amount of time that this session is valid. After the time has been exceeded, the
web-authenticated session is terminated. The RADIUS-supplied session timeout takes precedence over
the locally configured value.
To specify the timeout period for the global web-based proxy authentication sessions, perform this task
in privileged mode:
This example shows how to specify the timeout period for the global web-based proxy authentication
sessions:
Console> (enable) set web-auth session-timeout 20
web-authentication session-timeout set to 20 seconds.
Console> (enable)
Specifying the Quiet Period
When the authenticator cannot authenticate the host, it remains idle for a set period of time and then tries
again. The idle time is determined by the quiet-period value. The default is 60 seconds. You may set the
seconds value from 0 to 65535 seconds.
Task Command
Configure the URL for the login-fail page. set web-auth login-fail-page url url
Task Command
Specify the timeout period for the global
web-based proxy authentication sessions.
set web-auth session-timeout seconds
To Next Page
Loading...
