EasyManua.ls Logo

Cisco WS-C6506 - Syslog Additions

Cisco WS-C6506
1488 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
53-25
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 53 Using Automatic QoS
Using the Automatic QoS Macro on the Switch
If the above policer names are already in use, the macro attempts the following names:
POLICE_SOFTPHONE-DSCP46-x-y-z
POLICE_SOFTPHONE-DSCP26-x-y-z
where z = 1 to 99 starting from 1. Both names must pass with the same z value or the macro attempts the
next z value until both names are valid with the same z value. If the z = 99 attempt fails, this error
message displays and all settings remain unchanged:
Console> (enable) set port qos 4/1 autoqos voip ciscosoftphone
ERROR: QoS policer name in use, could not configure QoS policer.
Rename existing QoS policer POLICE_SOFTPHONE-DSCP46-4-1 and/or
POLICE_SOFTPHONE-DSCP26-4-1.
Autoqos did not complete. Settings remain unchanged.
Console> (enable)
QoS Disabled
When executing any port-based automatic QoS command on an interface where QoS is disabled, a
notification message appears in the CLI as follows:
Console> (enable) set port qos 4/1 autoqos voip ciscosoftphone
Port 4/1 ingress QoS configured for ciscosoftphone. Policing configured on 4/1.
QoS is disabled, changes will take effect after QoS is enabled.
It is recommended to execute the "set qos autoqos" global command if not executed
previously.
Console> (enable)
syslog Additions
Set the switch logging level to 4 or 5 for the QoS facility (set logging level qos 5) as follows:
Log level 4 = Warnings
Log level 5 = Notices
These sections describe the syslog additions for the automatic QoS features:
CDP Warning —Warning Level, page 53-25
Interface Change for All Ports Required—Warning Level, page 53-26
CDP Warning Warning Level
When executing the port-based automatic QoS voip ciscoipphone keyword on a port where either CDP
is disabled on the port or globally, or is running in version 1 mode, a warning message displays as
follows:
Console> (enable)
2001 Jun 02 09:20:42 %QOS-4-DEVICE_CDP_DIS:Trust-Device feature enabled with CDP disabled
or running in v1 mode.
Console> (enable)

Table of Contents

Related product manuals