55-38
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 55 Configuring a VoIP Network
Using SmartPorts
(*)Runtime trust type set to untrusted.
Config:
Port ACL name Type
----- -------------------------------- ----
No ACL is mapped to port 4/1.
Runtime:
Port ACL name Type
----- -------------------------------- ----
No ACL is mapped to port 4/1.
Console> (enable)
Using SmartPorts
The SmartPorts feature consists of two macros that simplify voice configuration on the Catalyst 6500
series switches. The SmartPorts macros cover all the voice configuration tasks that are required for
implementing the recommended Architecture for Voice, Video, and Integrated Data (AVVID) settings
for a voice port.
SmartPorts focuses on the voice networks that are built using the Cisco IP Phone 79xx series and the
Cisco SoftPhone. With SmartPorts, you use the ciscoipphone or ciscosoftphone keywords to initiate the
macros that specify the type of voice parameters that you desire on a particular port.
SmartPorts is described in these sections:
• Understanding SmartPorts Macros, page 55-38
• SmartPorts—Cisco IP Phone, page 55-39
• SmartPorts—Cisco Softphone, page 55-39
• SmartPorts Guidelines and Restrictions, page 55-40
• CLI Interface for SmartPorts, page 55-41
• Detailed SmartPorts Statements, page 55-42
• How to Use SmartPorts in Your Network, page 55-43
• SmartPorts Enhancements in Software Release 8.4(1), page 55-44
• Configuring User-Definable SmartPorts Macros, page 55-47
Understanding SmartPorts Macros
When you execute the SmartPorts macros on a port using the ciscoipphone or ciscosoftphone keywords,
these features are implemented:
• The port is enabled.
• The Layer 2 protocol is disabled for CDP, STP, and VTP.
• The port membership is set to “static.”
• The set port host command is executed on the port.
• The specified data VLAN is associated with the port.
• The global automatic QoS command is executed.
To Next Page
Loading...
Need help?
General