14-13
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 14 Configuring MLS
Configuration Guidelines and Restrictions
Table 14-2 shows the default IP MMLS switch configuration.
Table 14-3 shows the default IP MMLS MSFC configuration.
Table 14-4 shows the default IPX MLS configuration.
Configuration Guidelines and Restrictions
These sections describe the configuration guidelines and restrictions for IP MLS, IP MMLS, and IPX
MLS:
• IP MLS, page 14-13
• IP MMLS, page 14-14
• IPX MLS, page 14-15
IP MLS
These sections describe the IP MLS configuration guidelines:
• Maximum Transmission Unit Size, page 14-14
• Restrictions on Using IP Routing Commands with IP MLS Enabled, page 14-14
Table 14-2 Default IP MMLS Supervisor Engine Configuration
Feature Default Value
Multicast services (IGMP snooping or GMRP) Disabled
IP MMLS Enabled
Table 14-3 Default IP MMLS MSFC Configuration
Feature Default Value
Multicast routing Disabled globally
IP PIM routing Disabled on all interfaces
IP MMLS Threshold Unconfigured—no default value
IP MMLS Enabled when multicast routing is enabled and IP
PIM is enabled on the interface
Table 14-4 Default IPX MLS Configuration
Feature Default Value
IPX MLS enable state Enabled
IPX MLS aging time 256 seconds
To Next Page
Loading...
Need help?
General