Cisco WS-C6506 - Disabling MVRP Globally; Clearing MVRP Configuration; Clearing MVRP Counters

18-11
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 18 Configuring MVRP
Configuring MVRP on the Switch
This example shows how to disable MVRP on a port 3/14:
Console> (enable) set port mvrp 3/14 disable
MVRP is disabled on port(s) 3/14.
Console> (enable)
Disabling MVRP Globally
To disable MVRP globally on the switch, perform this task in privileged mode:
This example shows how to disable MVRP globally on the switch:
Console> (enable) set mvrp disable
MVRP is disabled on the switch.
Console> (enable)
Clearing MVRP Configuration
To clear all MVRP configuration on the switch, perform this task in privileged mode
:
This example shows how to clear all MVRP configuration on the switch:
Console> (enable) clear mvrp configuration all
Warning:MVRP configuration will be cleared.
Do you want to continue (y/n) [y]? y
MVRP configuration is cleared for all ports on the switch.
Console> (enable)
Clearing MVRP Counters
To clear all MVRP counters on the switch, perform this task in privileged mode:
Task Command
Step 1
Disable MVRP on an individual trunk port. set port mvrp mod/port disable
Step 2
Verify the configuration. show mvrp configuration
Task Command
Disable MVRP on the switch. set mvrp disable
Task Command
Clear MVRP configuration. clear mvrp configuration {all | mod/port}
Task Command
Clear all MVRP counters. clear mvrp counters