Cisco WS-C6506 - Router 2 Configuration; Localdirector Configuration

54-24
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 54 Configuring ASLB
ASLB Redundant Configuration Example
full-duplex
standby 1 ip 7.0.0.1
standby 1 track FastEthernet2
!
interface FastEthernet2
ip address 5.0.0.100 255.0.0.0
no ip redirects
no ip directed-broadcast
no ip route-cache distributed
no keepalive
full-duplex
standby priority 250
standby 2 ip 5.0.0.2
standby 2 track FastEthernet1
!
ip route 13.13.13.13 255.255.255.255 5.0.0.1
Router 2 Configuration
The router 2 configuration is as follows:
interface FastEthernet1
ip address 7.0.0.101 255.0.0.0
no ip redirects
no ip directed-broadcast
no ip route-cache distributed
load-interval 30
no keepalive
full-duplex
standby 1 ip 7.0.0.1
standby 1 track FastEthernet2
!
interface FastEthernet2
ip address 5.0.0.101 255.0.0.0
no ip redirects
no ip directed-broadcast
no ip route-cache distributed
no keepalive
full-duplex
standby priority 250
standby 2 ip 5.0.0.2
standby 2 track FastEthernet1
!
ip route 13.13.13.13 255.255.255.255 5.0.0.1
LocalDirector Configuration
The LocalDirector 1 and LocalDirector 2 configuration is as follows (the configuration is the same for
both LocalDirectors):
no shutdown ethernet 0
no shutdown ethernet 4
interface ethernet 0 100full
interface ethernet 4 100full
ip address 5.0.0.1 255.0.0.0
failover ip address 5.0.0.5
virtual 13.13.13.13:80:0:tcp is
virtual 13.13.13.13:23:0:tcp is
predictor 13.13.13.13:80:0:tcp roundrobin
predictor 13.13.13.13:23:0:tcp roundrobin