55-41
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 55 Configuring a VoIP Network
Using SmartPorts
CLI Interface for SmartPorts
These sections describe the CLI interface for SmartPorts:
• Command Description, page 55-41
• ciscoipphone Command Output, page 55-41
• ciscosoftphone Command Output, page 55-42
Command Description
You must specify either the ciscoipphone or ciscosoftphone keywords and a data VLAN. Specifying an
auxiliary VLAN is optional for the ciscoipphone keyword. The RSPAN and private VLANs are not
supported. The command syntax for SmartPorts is as follows:
Console> (enable) set port macro
Usage: set port macro <mod/ports..> ciscoipphone vlan <vlan> [auxvlan <auxvlan>]
set port macro <mod/ports..> ciscosoftphone vlan <vlan>
Console> (enable)
Note The set port macro mod/ports... ciscoipphone vlan vlan [auxvlan auxvlan] command enables the
“cdpverify” feature on the port.
ciscoipphone Command Output
When you enter the ciscoipphone keyword, the following displays (specifying the auxiliary VLAN is
optional):
Console> (enable) set port macro 3/1 ciscoipphone vlan 2 auxvlan 3
Port 3/1 enabled.
Layer 2 protocol tunneling disabled for CDP STP VTP on port(s) 3/1.
Port 3/1 vlan assignment set to static.
Spantree port fast start option set to default for ports 3/1.
Port(s) 3/1 channel mode set to off.
Warning: Connecting Layer 2 devices to a fast start port can cause
temporary spanning tree loops. Use with caution.
Spantree port 3/1 fast start enabled.
Dot1q tunnel feature disabled on port(s) 3/1.
Port(s) 3/1 trunk mode set to off.
VLAN Mod/Ports
---- -----------------------
2 2/1
3/1
16/1
AuxiliaryVlan Status Mod/Ports
------------- --------
------------------------------------------------------
3 inactive 3/1
Vlan 3 is not active.
Inline power for port 3/1 set to auto.
CDP enabled globally
CDP enabled on port 3/1.
CDP version set to v2
........
To Next Page
Loading...
