33-12
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 33 Configuring DHCP Snooping and IP Source Guard
Specifying the DHCP-Snooping IP Address-to-MAC Address Binding on a Per-Port Basis
Specifying the DHCP-Snooping IP Address-to-MAC Address
Binding on a Per-Port Basis
To specify the IP address-to-MAC address binding for the specified port, perform this task in privileged
mode:
This example shows how to specify the IP address-to-MAC address binding for the specified port:
Console> (enable) set port dhcp-snooping 5/29 add-binding 172.20.52.67 00-01-7b-9b-05-3f 1
DHCP Snooping Binding addition successful for Port 5/29, Vlan 1
IP addr 172.20.52.67, Mac Addr 00-01-7b-9b-05-3f.
Console> (enable)
Displaying DHCP-Snooping Information
You can display the DHCP-snooping binding table and configuration information using the commands
in this section.
Displaying the Binding Table
The DHCP-snooping binding table for each switch contains the binding entries that correspond to the
untrusted ports. The table does not contain information about the hosts that are interconnected with a
trusted port, because each interconnected switch has its own binding table.
To display DHCP-snooping binding table information, perform this task in privileged mode:
This example shows how to display the DHCP-snooping binding information for a switch:
Console# show dhcp-snooping bindings
MacAddress IpAddress Lease(sec) VLAN Port
------------------ --------------- ---------- ---- -----
00-01-7b-9b-05-3f 192.168.80.221 86377 810 1/8
Table 33-2 describes the fields in the show dhcp-snooping binding command output.
Task Command
Step 1
Specify the IP address-to-MAC address
binding for the specified port.
set port dhcp-snooping mod/port add-binding ip-addr
mac-addr [vlan]
Step 2
Display the DHCP-snooping configuration. show port dhcp-snooping [mod[/ports]]
Task Command
Display the DHCP-snooping binding table information. show dhcp-snooping bindings
To Next Page
Loading...
