42-13
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 42 Configuring Web-Based Proxy Authentication
Configuring Web-Based Proxy Authentication
To specify the duration of the quiet period, perform this task in privileged mode:
This example shows how to specify the quiet period:
Console> (enable) set web-auth quiet-timeout 20
web-authentication quiet-timeout set to 20 seconds.
Console> (enable)
Specifying the Maximum Login Attempts
You can specify the maximum number of unsuccessful login attempts allowed before blocking the user.
To specify the maximum number of login attempts, perform this task in privileged mode:
This example shows how to specify the maximum number of login attempts:
Console> (enable) set web-auth login-attempts
web-authentication max retry count set to <count>
Console> (enable)
Displaying Web-Based Proxy Authentication Information
This section describes how you can display the following web-based proxy authentication information:
• Displaying Summary of Session Information, page 42-13
• Displaying Per-Port Information, page 42-14
Displaying Summary of Session Information
If you specify the vlan vlan_id keyword and argument, a summary of information for the specified
VLAN is displayed.
In the command output display, the following applies:
• The * indicates the RADIUS assigned value.
• The State field displays the current web-authentication state for the given host.
To display a summary of information about the web-based proxy authentication session, perform this
task in normal mode:
Task Command
Specify the quiet period. set web-auth quiet-timeout seconds
Task Command
Specify the maximum number of login attempts. set web-auth login-attempts count
Task Command
Display a summary of information for the
web-based proxy authentication session.
show web-auth summary [vlan vlan_id]
To Next Page
Loading...
Need help?
General