Need help?Do you have a question about the Citizen 3530A and is the answer not in the manual?
Identifies and describes individual watch components and their functions.
Explains how to switch between normal time and chronograph displays.
Provides instructions for setting the normal time on the watch.
Details how to operate the chronograph functions for normal use.
Explains how to use the chronograph as a counter.
Instructions for activating and deactivating the alarm function.
Describes switching between normal time and alarm setting displays.
Guides on how to set the alarm time for specific models.
Details on using the chronograph function as a timer.
Explains the alarm monitor function and its operation.
Describes how the watch indicates the remaining power cell life.
Instructions for safely installing and removing the power cell.
Guidance on correctly mounting the watch mechanism parts.
Steps for mounting the train wheels and pinions correctly.
Specific instructions for fitting the chronograph guard correctly.
Special handling advice for the moon's age plate on model 3570.
Procedure for detaching the setting and switch setting stems.
Details the disassembly and assembly steps for the dial side.
Outlines the disassembly and assembly procedures for the power cell side.
Explains how the crown operation changes watch functions.
Details how to correct normal and alarm times using the crown.
Describes the operation of the alarm switch for ON/OFF functions.
Explains switching between normal time and chronograph displays.
Instructions for starting and stopping the chronograph function.
How to start and stop the timer function.
Procedures for setting and resetting the chronograph/timer/counter.
Details the operation of the hour/minute recording wheels.
Procedure to measure the power cell voltage and its implications.
How to check the watch's output signals from step motors.
Steps to check for loose screws and dust affecting connections.
Instructions for measuring the resistance of the watch coils.
How to inspect the train wheels for smooth operation and cleanliness.
Verifies the proper functioning of the indicator mechanism.
Checks the output signal for the CG 2/100 sec. timing.
Verifies the smooth operation and mounting of button A's mechanism.
Inspects the CG train wheel for proper meshing and lubrication.
Checks CG connection parts for loose screws or dust.
Measures the resistance of the chronograph coil unit.
Procedure for measuring and adjusting the watch's time rate.
Checks how the watch is used by customers.
Verifies switch mechanism functions and proper mounting.
Tests the alarm output and checks assembled parts.
Verifies calendar and moon age mechanisms for correct assembly.
Measures current consumption in normal and chronograph modes.
To Next Page
General