1. When the second hand reaches the 12:00
position, pull out the crown to position 2
(time adjustment position).
2. Turn the crown to the right (clockwise)
to adjust the time.
Adjust the time while paying attention to
a.m./p.m. by noting the time at which the
date changes.
3. Set the time to the time signal time, etc. and
return the crown to the normal position.
[NOTE]
① If you adjust the day of month when a time between 9:00 p.m. and
12:00 midnight is being displayed, the day of month sometimes does
not change to the next day even if the actual date changes. Avoid
changing the day of month during this time period.
② The day of month indicated by this watch follows a 31-day cycle.
To advance to the 1st of the next month after a short month (a month
having 30 days or February), pull out the crown to position 1 and turn
it to the left.
③ Avoid adjusting the month when the day hand indicates a day from
the 31st to the 2nd.
To make adjustment during this period, first set the day of month
outside the range of the 31st to the 2nd, and then adjust the month.
Then, set the day of month that the day hand should point to.
<Setting the Time>
Crown
Position 2
01 2
[Hints for accurate adjustment]
e time can be more accurately adjusted by rst stopping the second hand
at the 12:00 position, advancing 4 to 5 minutes past the time that the hour
and minute hand are to be set to, and then set the current time by backing
the hands into position by rotating the hands counterclockwise.
To Next Page
Loading...
