Automatic winding structure
Winding direction : Clockwise (seeing from case back side)
Operating method
Winding the mainspring, adjusting the hand, date is done by the below procedure.
(1) Winding the mainspring
Automatic winding watch can be also manual-winded by turning the crown in "A" position.
Wind 15～20 times clockwise until second hand starts to move naturally.
(2) Adjusting date
Adjust the date by rotating the crown in "B" position.
* If the date is adjusted between the hours of around 8:30 PM and 2:00 AM the date may not change
on the following day.
(3) Adjusting time
Rotate the crown in "C" position and adjust the standard time.
Then check if it is morning or afternoon and adjust correctly.
Separated parts
These specifications might be changed without prior notice.
Plastic movement holder
500-002 x 1
Winding stem
Screw for dial fixing
Spacer
212-A47 x 1
929-808 x 2
065-A05 x 1
To Previous Page
Loading...
