47
Checking and correcting the reference position Checking and correcting the reference position
4
Press and release the upper left button .
Each time you press the button, the hand moves by 1 step.
•The hand moves continuously while you are pressing and holding the button.
5
Press and release the lower left button to change the hand to be
corrected.
Each time you press and release the lower left button , the target hand moves
slightly to indicate it is adjustable.
•The target hand changes in the following order: 100 m hand (compass hand)
→ 2.5 m hand → 1 000 m hand → (back to the beginning)
6
Repeat steps 4 and 5 to correct the reference positions of all the hands.
7
Push the crown in to position to finish the procedure.
To Next Page