4746
4. This fully lit display is canceled when the crown is returned to the normal
position.
• After cancelling, a confirmation tone is sounded after which each of the
hands perform a demonstration movement in the order of the second hand,
minute hand, UTC minute hand, UTC hour hand, the hour hand, and the 24
hour hand to indicate that the all-reset procedure has been completed.
• After the demonstration movement, pull the crown out to the second click to
switch the setting to the watch base position setting state.
Always make sure to set the 0 position (base position) for the hour hand,
minute hand, second hand, 24-hour hand and UTC hour and minute hands
while referring to "4. Checking 0-Position of Each Hand <0-Position
Correction>".
Note:
• After setting the 0 position (base position) for each hand, correctly reset the
time, calendar and other modes before using the watch.
<All-Reset Procedure>
1. Turn the crown to set the mode hand to the chronograph [CHR] mode.
2. Pull out the crown to the second click.
• The second hand, minute hand, hour hand, 24 hour hand, UTC hour hand
and UTC minute hand rapidly advance to the 0 position stored in memory.
3. Press buttons (A), (B) and (C) simultaneously and then release.
• All segments of the digital display are shown when either of the buttons is
released.
To Next Page
Loading...
