— 5 —
Do not handle the equipment in the following manners, because problems may result.
● Do not print when there is no recording paper or ink ribbon set in the printer.
Otherwise, print head may be damaged.
● Be careful not to drop foreign substances, such as clips, pins, and screws, into the
equipment.
● Do not spill any liquid or spray any chemical-containing liquid over the equipment.
● Do not stamp on, drop, hit, or give a strong shock to the equipment.
● Never use a pointed object, such as a pen, to operate the operation panel.
● Do not use Scotch tape to fasten paper together for continuous use.
● Never pull the set paper forcibly or pull the paper in the direction reverse to the
paper feed direction.
● Replace the ink ribbon before it is broken by overuse. Do not refill the ink ribbon.
● Remove the ribbon cassette when the printer is left unused for a long time.
● Leaving the printer unused for a long time with a ribbon cassette loaded may cause
smudged printing. Continuous printing at low temperature may cause thin printing
due to the characteristic of ink.
● Do not deliver the printer with a ribbon cassette and roll paper loaded.
To Prevent Injury and Spreading of Damage
● Do not touch the printing part of the print head.
● While the equipment power is on, do not touch the moving parts, such as a cutter
and gear, or electric parts inside the equipment.
● Please place neither hand nor the finger when you open and shut the panel.
● Be careful to avoid bodily injure or damaging other objects with an edge of sheet
metal.
● Should any error occur while operating the equipment, stop using it immediately,
disconnect the power plug from the plug socket, and then contact your CITIZEN
SYSTEMS dealer.
● In case of a failure, do not attempt to disassemble the printer. Refer the repair service
to your nearest CITIZEN SYSTEMS dealer or service personnel.
PRECAUTIONS FOR HANDLING
To Next Page
Loading...
Need help?
General
