— Memory function works on for approximately 3 seconds
or until another switches are pressed. (Even if the last mea-
sured value is displayed, you are able to start the mea-
surements by pressing of “Start Switch” or you are able
to change the pressure-setting value by pressing of “Pres-
sure Setting Switch” or you are able to turn OFF by de-
pressing of “Power Switch”)
— Memory recall function does not work during automatic
inflation and blood pressure measurement are being made.
— New blood pressure value is stored in memory at press-
ing “Power Switch” for turn OFF or at pressing “Start
Switch” for new measurement.
10. Battery replacement
If the batteries become weak, the “ ” mark will appear in
the display, indicating that batteries should be replaced with
new ones.
Remove the battery cover at mainframe and replace the new
four pieces of batteries.
Type “AA” (R6P, LR6) battery or equivalent is suitable for
this blood pressure monitor.
9. Automatic power off function
If this unit is left on after measurement, an Automatic Power-
OFF Function turns the power OFF after approximately 3 min-
utes. To continue measurement press the power switch to
turn the unit ON.
English
- Eng 11 -
To Next Page
Loading...
Need help?
General
