DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION
DESCRIPTION OF DISPLAY MARKS
Measurement is begun, but the pressure
was insufficient.
Change the pressurization setting one level by pressing
“Pressure Setting Switch” and measure once again.
(Automatic re-measuring will be done only 1 time.)
Appears when the blood pressure could
not be measured accurately. (Some
noise was detected or moved arm dur-
ing measuring.)
Repeat measurement again.
First exhaust air from the cuff, reapply the cuff properly
and remeasure.
Appears when the pulse could not ac-
curately be measured.
Replace the batteries.
Appears when the batteries become
weak.
Appears when no memory is stored at
pressing of “Memory Recall Switch”
Take a measurement.
Blood pressure will store automatically.
Units has a trouble.
Ask purchased shop.
- Eng 12 -
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE/min
AVE.
12 34 567
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE/min
AVE.
12 34 567
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE/min
AVE.
12 34 567
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE/min
AVE.
12 34 567
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE/min
AVE.
12 34 567
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE/min
AVE.
12 34 567
To Next Page
Loading...
Need help?
General
