—35—
Change the settings of the paper near-end sensor to set the position at which
the near-end of the paper is detected.
1. Use a pointed object, such as a pen, to gently press the button to change the paper
near-end sensor.
2. Press and hold down the button while moving the paper near-end sensor up and
down. The sensor positions are shown below for the various diameters of the paper
roll used.
*: Position of sensor when shipped from factory. However, factory settings differ depending on the
destination market.
3.10 Adjusting the Paper Near-end Sensor
(Unit: mm)
Sensor position
Exterior diameter when detected as
near end
Exterior/ interior diameter of core of
paper roll used
A Approximately 31 18/12
B
* Approximately 23 18/12
C Paper near-end sensor function is off
The diameter of the roll of paper that is detected is an estimate. Some variations may
occur depending on the paper.
Button to change paper
near-end sensor
To Next Page
Loading...
