If the watch is set to the "diving mode",
1) A swimming diver is displayed in the dot indicator to indicate that the
watch is in the diving mode.
2) The LED flashes every 4 seconds to indicate that the watch is in the diving
mode.
3) The depth is measured and indicated at the interval of 1 second. The
measurement range of the depth is 1.0 m(4ft) - 80.0m(260ft). If the depth
exceeds 80.0 m(260ft), "- -. –m”(“- -. –f”) is indicated, and if the former
is less than 1.0 m(4ft), "0.0 m(0.0ft)” is indicated to shown the diver that
the watch is out of the measurement range.
4) The diving time is measured and indicated by the unit of 1 second for the
first 29 minutes and 59 seconds, then by the unit of 1 minute up to 199
minutes. After 199 minutes, the watch starts measurement again from 0
seconds.
5) The watch starts indicating the water temperature 1 minute after the diving
is started, then it continue the measurement and indication at the interval
of 1 minute. The measurement range of the water temperature is -5"C –
40’C(27-57F). The watch indicates "- -IC" out of this range.
6) While the (A)(lower right) button is pushed, the watch indicates the present
time. If the (A)(lower right) button is released, the watch starts
indicating the depth again about 1.5 seconds after. While the (C)(Upper
Left) button is pushed, the lamp lights up for 10 seconds maximum. The lamp
goes off about 1.5 seconds after the (C)(Upper Left) button is released.
Example: Watch gets ready for diving mode from the "time and calendar mode".
Resetting the diving mode
1) If the watch is kept in water shallower than 1m(4ft) (indicated depth:
0m(0ft)) for about 10 minutes, the diving mode is reset automatically. After
the diving mode is reset, the watch is set as follows, depending on the
diving condition.
a. In case of valid diving:
The watch is set to the surface mode (for measurement of rest time
above water).
b. In case of invalid diving:
The watch is set to the time and calendar mode or the surface mode
which has been continued from the previous time.
2) If the (M)(lower left) button is pushed and held for 2 seconds, the diving
mode is reset. After the diving mode is reset, the watch is set as explained
in section 1 above. If the water sensor is wet, however, the dot indicator
indicates the diver and mode alternately.
Return to Table of Contents
Return to Table of Contents
To Next Page
Loading...
