2/3
E650 Abbreviated instruction
Receiving the signal manually (on-demand reception)
• It takes 2-15 minutes to finish reception.
1.
Change the mode to [LON], [NYC], [CHI], [DEN] or [LAX] and push
the crown in to position
0
.
2.
Press and hold the lower right button
A
for 2 seconds or more.
The second hand points “RX”, the alarm sounds and signal reception starts.
The alarm sound and the second hand returns to normal movement as the
reception finished.
Reception was successful
The time will be updated.
Reception failed
The time is not corrected and the previously set time
resumes.
• Press and hold button
A
for 2 seconds or more to cancel reception.
About signal reception
On this watch, signal reception status varies depending on the mode.
Mode Signal reception status
Time difference
from UTC
LON
The watch tries to receive the standard signal from the
German station (DCF77).
0 hour
NYC
The watch tries to receive the standard signal from the
US station (WWVB).
−5 hours
CHI
−6 hours
DEN
−7 hours
LAX
−8 hours
CHR
The watch does not receive any signal.
ALM
A-TM
Freely adjustable
Adjusting the time and calendar manually
You can manually adjust the time and calendar in the mode [LON], [NYC], [CHI],
[DEN] and [LAX].
• The adjustment result in any one of the modes [LON], [NYC], [CHI], [DEN]
and [LAX] is automatically reflected in the other modes including [A-TM] with
their time difference calculated.
1.
Change the mode to [LON], [NYC], [CHI], [DEN] or [LAX] and pull
the crown out to position
2
.
2.
Press and release the lower right button
A
.
The second hand stops at 0 second and the hour and minute hands move.
3.
Press and release the lower right button
A
repeatedly to
change the hand/indication to be corrected.
• Each time you press button
A
, the target changes as follows:
• Hour/minute → date → year/month → day of week → (back to the top)
• The hands and indications slightly move when selected to show they
become adjustable.
4.
Rotate the crown to adjust the hand/indication.
• The hour, minute and 24-hour hands move synchronously.
• Check whether the time set is AM or PM with the 24-hour hand.
• Date indication changes to the next as the function hand rotates 5 times.
• Rotating the crown quickly a few times moves the hand/indication
continuously when you set time and date. To stop the rapid movement,
rotate the crown in either direction.
• Year and month are set by adjusting the position of the second hand.
24 60
30
12
6
18
S
M
T
W
T
F
S
ON
OFF
ON
OFF
A
L
M
M
T
E
M
T
E
L
A
M
L
A
M
H
C
R
T
L
-
M
T
L
-
M
H
C
R
12
1
2
3
4
5
6
7
8
9
10
11
“Month” corresponds to one of
the 12 zones shown in the figure
below.
Each number means month.
“Year” corresponds to the years
since leap year and is indicated
with markers in the zone of each
month.
60
S
M
T
W
T
F
S
OFF
A
L
M
M
T
E
M
T
E
L
A
M
L
A
M
H
C
R
T
L
-
M
T
L
-
M
H
C
R
Years since leap year:
0
(Leap year)
0
Years since leap year:
1
1
Years since leap year:
2
2
3
Years since leap year:
3
Year
Years since leap
year
Second hand position
2016 2020 2024 2028 0
(Leap year) Hour marker
2017 2021 2025 2029 1
1st min. marker
2018 2022 2026 2030 2
2nd min. marker
2019 2023 2027 2031 3
3rd min. marker
5.
Repeat steps 3 and 4.
6.
Push the crown in to position
0
in accordance with a reliable
time source.
Indicating the time and calendar of an area you like
You can set time difference from UTC in 15 minute increments and make the
watch indicate time and calendar of an area other than [LON], [NYC], [CHI],
[DEN] and [LAX].
• The time in the [A-TM] mode is adjustable within a range of ±26 hours from
UTC. When summer time is activated, the adjustable range becomes -25 ‒ +27
hours.
• Signal reception is not performed when the mode is [A-TM].
• The time and calendar of [A-TM] are automatically adjusted accordingly when
signal reception is performed in any of the following modes, [LON], [NYC],
[CHI], [DEN] and [LAX].
1.
Change the mode to [A-TM] and pull the crown out to position
2
.
The time and calendar currently set are indicated. The second hand indicates
the current summer time setting of [A-TM].
2.
Rotate the crown to adjust the hour hand.
• The hour hand moves in 1-hour increments. The 24-hour hand and date/
day of week indication move synchronously with it.
• When you rotate the crown quickly, the hands/indication will move
continuously. To stop the rapid movement, rotate the crown in either
direction.
3.
Press and release the lower right button
A
to adjust the
minute hand.
• The minute hand moves in 15 minute increments. The hour hand does not
move with the minute hand even after it moves fully around.
4.
Push the crown in to position
0
to finish the procedure.
To Next Page
Loading...
