51
Troubleshooting Troubleshooting
1
Check the power reserve indication.
• Charge if the power reserve level is lower than “2”.
2
Pull the crown out to position .
The water depth hand and maximum water depth
hand move to their current reference positions. Do not
execute any operation until all the hands stop.
3
Press and hold both the upper left button
and lower left button
at the same time for 4
seconds or more.
As you release the buttons, the hands move slightly to
indicate that reset is completed.
Correct the reference position (page
41
) and adjust
the time (page
34
) and calendar (page
35
).
• Make sure that the
watch is not wet
before operating
the crown or any
buttons.
• To unscrew/screw
the crown/button,
see page
11
.
To Next Page
Loading...
