47
Checking and correcting the reference position Checking and correcting the reference position
Each time you press the button, the hand moves by 1 step.
The hand moves continuously while you are pressing and holding the button.
5
Press button to change the hand to be corrected.
Each time you press the button, the target hand moves slightly to indicate it is
adjustable.
The target hand changes in the following order: 100 m hand (compass hand) →
2.5 m hand → 1 000 m hand → (back to the beginning)
6
Repeat steps 4 and 5 to correct the reference positions of all the hands.
7
Push the crown in to position to finish the procedure.
To Next Page
Loading...
