36 37
English
1-2. Press and hold button
B
until the figures start moving to show the
current reference position.
Check the current reference position after the figures have stopped moving.
Position of figures The status of the reference position
“0”s of both digits are
shown upright.
The reference position is correct.
Go to step 1-3.
Other than above
Ex.
The reference position is wrong.
Go to step 2-1 to correct it (→ page 38).
• Follow step 2-1 within two minutes.
1-3. Press button
B
to finish the procedure.
The current date will appear in the date window.
• The current date will also appear in the date window if no operation is done for
about two minutes after step 1-2.
Go to the next page
To Next Page
Loading...
