1/3
H149 Abbreviated instruction
• This watch is solar-powered. Expose the dial to light and use it sufficiently charged.
• To see details of charging time, specifications, and operations, refer to the instruction manual:
H149 instruction manual
English
Component identification
• Actual appearance may differ from the illustration.
• The crown has two positions when pulling it out.
Checking the power reserve
1.
Push the crown in to position
0
.
2.
Press and release the lower right button
A
.
The second hand moves to indicate the power reserve.
Second hand movement Power reserve status
Pointing “O (OK)” or “N (NO)” after moving
clockwise
Power reserve is sufficient.
Pointing
“O (OK)” or “N (NO)” after moving
counterclockwise
Charge immediately
• “O (OK)” and “N (NO)” indicate the time signal reception result. They
have no relation to the charge level.
3.
Press and release the lower right button
A
to finish the
procedure.
The indication returns to current time.
• It returns to current time indication automatically in about 10 seconds
without pressing the button.
Checking the signal reception result
1.
Push the crown in to position
0
.
2.
Press and release the lower right button
A
.
The second hand moves to indicate the result of the last reception.
Indication Reception result
O (OK)
The reception was successful.
N (NO)
The reception failed.
• Try signal reception following the steps in
Receiving the signal manually
(on-demand reception)
if the last reception failed.
3.
Press and release the lower right button
A
to finish the
procedure.
The indication returns to current time.
• It returns to current time indication automatically in about 10 seconds
without pressing the button.
Setting the world time
• The world time setting controls the target station from which the watch tries to
receive signals.
1.
Pull the crown out to position
1
.
The second hand moves to point the area currently set.
2.
Rotate the crown to select an area.
• Select an area from
Table of time zones and representative areas
• Each time you change the area, the time and date of the selected area is
shown.
3.
Push the crown in to position
0
to finish the procedure.
The indication returns to current time.
Crown's position
0 1 2
Summer time setting:
SMT ON/OFF
Button
A
Button
B
Reception result
indication:
O (OK)/N (NO)
Reception-in-progress
indication:
(R/RX)
Hour hand
Area name / time zone
Second hand
Minute hand
Date indication
Crown
To Next Page
Need help?
General
