Citizen iDP-3550 - Page 112

ESC "c" "4" n
[Function] Selecting the paper near end sensor valid for print stop
[Code] <1B>H<63>H<34>H n
[Range] 0 ≤ n ≤ 255
[Outline] This command selects the no-paper detector state in which printing should be stopped.
Value
Bit Function
0 1
0 Paper near end Disabled Enabled
1 Undefined
− −
2 Undefined
− −
3 Undefined
− −
4 Undefined
− −
5 Undefined
− −
6 Undefined
− −
7 Undefined
− −
[Default] n = 0
ESC "c" "5" n
[Function] Selecting the panel switch enable/disable
[Code] <1B>H <63>H <35>H n
[Range] 0 ≤ n ≤ 255
[Outline] This command enables/disables the panel switches. n is valid only for the least significant
bit.
Setting n = 1 disables the panel switches.
Setting n = 0 enables the panel switches.
[Caution] If the panel switches are disabled with this command, the LF switch will be disabled.
Therefore, the paper cannot be fed by the LF switch.
[Default] n = 0
ESC "d" n
[Function] Printing and n-line paper feed
[Code] <1B>H <64>H n
[Range] 0 ≤ n ≤ 255
[Outline] This command feeds the paper by n-lines after printing the one line worth of data saved in the
print buffer.