Citizen J290 - Page 45

45
Checkingthereferenceposition
Check whether the reference positions of the 10 000 ft hand, 1 000 ft hand (compass
hand) and 25 ft hand are correct.
1
Stop altitude measurement or compass function
and check the power reserve indication.
•Charge the watch if the power reserve is lower than
“2”.
2
Pull the crown out to position
.
The hands move to their reference position.
3
Check the reference positions.
Check the reference positions of the hands by referring
to the illustration of the previous page.
If any reference position is incorrect, correct it following
step 3 and after on page
46
.
4
Push the crown in to position
to finish the
procedure.
Checking and correcting the reference position