Citizen u700 - Key Watch Features; Lap Time Measurement; Eco-Drive Technology

4/4
U700 Abbreviated instruction
Correcting the reference position
1.
Press and release the lower left button
M
repeatedly to
change the mode to “Chronograph”.
2.
Pull out the crown.
The hands move to the current reference positions stored in memory.
3.
Press and hold the upper right button
B
for 2 seconds.
“CRS” is displayed and the second hand becomes adjustable.
4.
Press and release the lower right button
A
or upper right
button
B
repeatedly to adjust the setting.
5.
Press the lower left button
M
repeatedly to change the hands
to be corrected.
• Each time you press button
M
, the target changes as follows:
Chronograph second hand (“CRS”)
Chronograph 1/10 second hand
Chronograph 1/100 second hand (“CRM”)
Hour and 24-hour hands (“HR”)
Second and minute hands (“MIN”)
• Actual appearance may differ from the illustration.
6.
Press and release the lower right button
A
or upper right
button
B
repeatedly to adjust the reference positions.
• Pressing and holding any of the buttons changes hands continuously.
• Use button
B
to adjust chronograph hands.
• The minute and second hands move 3 minutes 30 seconds while adjusting
the chronograph 1/10 hand, chronograph 1/100 second hand, hour hand
and 24-hour hand to make them easy to see.
7.
Push in the crown to finish the procedure.
Resetting the watch - All Reset
1.
Pull out the crown.
2.
Press and hold buttons
A
,
B
and
M
at the same time.
A confirmation alarm sounds and “0” is displayed in the digital display.
After All Reset
Correct the reference positions referring to “Correcting the reference position”.
After that, set the time, calendar and the alarm.
Checking the reference positions
1.
Press and release the lower left button
M
repeatedly to
change the mode to “Chronograph”.
2.
Pull out the crown out.
“0” is displayed in the digital display and all hands move to indicate the
current reference position.
• Correct reference positions:
Chronograph second hand: 0 (or 60)
Chronograph 1/10, 1/100 second hands:
0/.00
Hour, minute, and second hands: 12
o’clock position
24-hour hand: 24-hour position
When the current reference position is
different from the correct one, adjust the
position following the steps of “Correcting
the reference position”.
• The actual appearance and reference
position may differ from the illustration.
3.
Push in the crown to finish the procedure.