Citrix ADC MPX
The following components are visible on the back panel of the MPX 24xxx appliances:
• Non‑maskable interrupt (NMI) Button, used at the request of Technical Support to initiate a core
dump. To press this red button, which is recessed to prevent unintentional activation, use a pen,
pencil, or other pointed object. The NMI Button is also available remotely over the network in
the LOM GUI, in the Remote Control menu.
• System status LED, which indicates the status of the appliance, as described in Common hard‑
ware components.
Note: On an
MPX 24100/24150 appliance running LOMfirmwareversion 3.22, the system status LED indicates
an error (continuously glows RED) even though the appliance is functioning properly.
• Four power supplies, each rated at 750 watts, 100–240 volts. A minimum of two power supplies
are required for proper operation. The extra power supplies act as backup. Each power supply
has an LED that indicates the status of the power supply, as described in Common hardware
components.
• Power switch, which turns o power to the appliance. Press the switch for less than two seconds
to shut o the power.
• Two 128 GB or larger removable solid‑state drives.
Note: Drive densities might increase as components become EOL but its size is never smaller
than the original.
• One 500 GB or larger removable hard disk drive that is used to store user data.
For information about installing the rails, rack mounting the hardware, and connecting the cables,
see Installing the Hardware.
© 1999–2023 Cloud Soware Group, Inc. All rights reserved. 80
To Next Page
Loading...
Need help?
General
