106
Driving
Engaging reverse gear
The movement must be carried out slowly
to reduce noise.
To engage reverse gear, wait until the
vehicle is stationary.
Engaging 5
th
or 6
th
gear
F To fully engage the gear, move the gear
lever all the way to the right.
6-speed electronic
gearbox
Mode selection
For safety:
Position N can only be released if the
brake pedal is pressed.
The change from position A (driving in
automated mode) to position M (driving in
manual mode) or vice versa can be done
at any time. The indicator lamp A in the
instrument panel goes off.
Starting the vehicle
F To start the vehicle, the selector must be in
position N.
F Press firmly on the brake pedal.
F
Start the engine.
F
With the engine running, place the selector
on R, A or M as required.
F Release the brake pedal and press the
accelerator pedal to move off.
If the selector is not in position N, and/or if the
brake pedal is not pressed, the engine will not
start; begin the above procedure again.
Reverse gear
Engaging reverse gear
F In 6-speed configuration. lift the collar under
the knob.
- Automated mode: selector in position A.
-
Manual mode: selector in position M.
https://www.automotive-manuals.net/