39
3
Ease of use and comfort
Seat height (driver)
Head restraint height
F To remove the head restraint, press the
button and pull the head restraint upwards.
F To install the head restraint, engage the
rods of the head restraint in the holes,
keeping it in line with the backrest.
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
Armrest
Front heated seats control
When the seat and passenger
compartment have reached an adequate
temperature, you can stop the function;
reducing the consumption of electrical
current reduces fuel consumption.
F
To raise the seat, pull the control upwards
and then take your weight off the seat.
F To lower the seat, pull the control upwards
and then push on the seat.
F
To raise the head restraint, slide it vertically
upwards.
F
To lower it, press the button and slide the
head restraint vertically downwards.
The adjustment is correct when the upper edge
of the head restraint is level with the top of the
head.
F
To access the vertical position, raise the
armrest until it locks.
F Lower the armrest to return it to a position
for use.
F To remove the armrest, press the unlocking
button from the vertical position and remove
the armrest.
F
To put the armrest back in place, clip it on in
vertical position.
F If the vehicle is fitted with the auxiliary
console and an armrest, remove the
console or armrest to fold the passenger
seat into the table position.
Each individual front seat may be fitted with a
control located on the outer part of the seat.
With the 2+1 bench seat, the
driver's seat control starts or
stops seat heating of the outer
seat of the bench seat.
Press to start seat heating.
Press again to switch off.
https://www.automotive-manuals.net/
To Next Page
Loading...
Need help?
General
