ACTIVATION/DEACTIVATION OF VOICE
Give a short press on the end of the lighting
to activate this function.
Activation of the function is confi rmed by
a beep and by the opening of a window on
the display. The system is then listening. If
the word pronounced is understood by the
system, then it is displayed in the window
and a beep is heard. Otherwise the system
”. You then have to say the
Voice commands are deactivated automati-
cally and the system emits a double beep,
when an action has been completed using
If no voice commands are given, this function
is deactivated after a few seconds and the
A press on the end of the lighting control
, deactivates the function.
To obtain memorised radio station no.
to reply with a beep, then pronounce the word
”, wait for the system to reply with
a beep, then fi nish with the word
After the double beep, the desired action
”, you will see displayed all the com-
mands that are available at the moment of
Say the key words that correspond to the
action that you wish carried out.
If you should lose your way in the different
levels of the voice command structure, say
” to bring you back to the
voice commands at the previous level of
However careful the user may be, the pre-
recorded words or expressions will always be
more easily recognised than words recorded
Voice commands can control a certain
Using a voice label recorded by the user,
for example : “Office” or “
enhance the recognition of these labels,
you are recommended to record them
using different intonations.
Using pre-recorded words and expres-
sions, for example : “Radio”, “
The voice commands function in a logical
sequence. A word voiced at one level must
be recognised before another word at the
next level can be recognised.
To Next Page
Loading...
