CITROEN C3 PLURIEL - Page 125

ENGINE
119
CHECKING AND SETTING THE VALVE TIMING
Engine: 8HY
B1EP18ZC
Checks (continued).
NOTE: The index «e» of the dynamic tensioner roller should be centred within the area «d».
Check the correct positioning of the index «e».
If it is not correct, repeat the operation to tension the timing belt
(see corresponding operation) .
Refitting.
Refit the tool [1] at «a».
Remove the screw (8).
Refit:
- The upper timing cover (11).
- The lower timing cover (10).
- The accessories drive pulley (9).
- The screw (8).
Tightening:
- Screw (8):
Pre-tighten to : 3 ± 0,3 m.daN.
Angular tightening : 180° ± 5°.
Remove the tool [1].
C3
Angl.-T1-page 92-134-2005 9/01/06 9:16 Page 119