CITROEN C3 PLURIEL - Valve Clearance Settings; The valve clearances must be checked with the engine cold; POSSIBLE PROCEDURES

128
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: 9HX
B1BP2N1C
Tools.
[1] Flywheel setting peg : (-).0194.C
[2] Camshaft setting peg : (-).0194.B
[3] Crankshaft setting peg : (-).0194.A
IMPERATIVE: Respect the safety and cleanliness requirements specific to High pressure Diesel
injection (HDi) engine versions.
Checking the timing.
Raise and support the vehicle, wheels hanging.
Disconnect the battery.
Remove:
- The front RH wheel.
- The front RH splash-shield.
- The accessories drive belt
(see corresponding operation) .
Remove the engine supports (4) and (5).
Uncouple:
- The fuel supply unions (1).
- The air/air heat exchanger inlet (2) and outlet (3) pipes.
- The exhaust line (at the flexible pipe) .
Support the engine with a roller jack equipped with a block.
Turn the engine in its normal direction of rotation.
Peg the flywheel, using the peg [1] (at "a") .
C3
B1BP3AMC
Angl.-T1-page 92-134-2005 9/01/06 9:16 Page 128