206
Practical information
Towing another vehicle
) On the rear bumper, remove the cover
by pulling at the bottom using the jack
handle 1 .
) Screw in the towing eye 2 fully using the
wheelbrace 3 .
) Install the towing bar.
) Switch on the hazard warning lamps on
both vehicles.
) Move off gently and travel slowly for a short
distance only.
Access to the tooling
The towing eye and the tools are stored under
the boot floor.
To gain access to them:
) open the boot,
) lift and remove the boot floor,
) take the towing eye and the tools required.
List of tools
1. Jack handle.
2. Towing eye.
3. Wheelbrace.
To Next Page
Loading...
