213
8
Checks
Bonnet
) Open the right hand front door.
) Pull the interior bonnet release lever A ,
located at the bottom of the door aperture.
Do not open the bonnet in high winds.
When the engine is hot, handle the
exterior safety catch and the bonnet
stay with care (risk of burns).
) Unclip the stay C from its housing on the
back of the bonnet.
) Fix the stay in the notch to hold the bonnet
open.
Closing
) Take the stay out of the support notch.
) Clip the stay in its housing on the back of
the bonnet.
) Lower the bonnet and release it at the end
of its travel.
) Pull on the bonnet to check that it is
secured correctly.
The location of the interior bonnet release
lever prevents opening of the bonnet
while the right hand front door is closed.
Opening
) Push the exterior safety catch B to the left
and raise the bonnet.
This message appears in the instrument panel
screen if the bonnet is not fully closed.
The cooling fan may start after
switching off the engine: take care
with articles and clothing that might
become caught by the fan blades.
Because of the presence of electrical
equipment under the bonnet, it is
recommended that exposure to water
(rain, washing, ...) be limited.
To Next Page
Loading...
