220
Checks
Coolant level
The coolant level should be between
the two marks.
In addition, as the cooling system is
pressurised, wait at least one hour after
switching off the engine before carrying out any
work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop.
When the pressure has dropped, remove the
cap and top up the level.
Fluid specifi cation
The coolant must conform to the
manufacturer's recommendations.
The brake fluid level should be close
to the "MAX" mark. If it is not, check
the brake pad wear.
Brake fluid level
Changing the fl uid
Refer to the maintenance and warranty guide
for details of the interval for this operation.
Fluid specifi cation
The brake fluid must conform to the
manufacturer's recommendations and meet
the DOT3 or DOT4 standard.
The cooling fan may start after switching
off the engine: take care with articles and
clothing that might become caught by the
fan blades.
When the engine is warm, the temperature of
the coolant is regulated by the fan.
To Next Page
Loading...
